J3 Technology

The Water Leak Detection Panel range is designed to detect water leaks either at localised points using the WD-PS point sensor or larger areas with the WD-CS cable sensor, a rain sensor is also available. All these sensors are used with the WD-AMX range of modules that are suitable for DIN-rail mounting inside AHUs, power distribution units or general areas where leak detection is required. They are fitted as standard with LED indication of the water leak status, and sounder that can be disabled by simply removing a jumper. The WD-AMX relay output can either configured to be manual or auto reset. A relay output provides an alarm signal that can be used for connection to a BMS controller or remote alarm annunciation panel such as the UI-AA1-F.

              The J3 WATER LEAK DETECTION PROBE (J3-POINT SENSOR) is a special purpose probe designed to detect water leaks in specific locations. It is intended to be floor or tray mounted, using either screw or adhesive attachment. The J3-POINT SENSOR  can detect water leaks in low spots, drip trays or sumps, where J3 WATER LEAK DETECTION PROBE sensing cables are inappropriate.

            The J3-POINT SENSOR is designed to be integrated as a part of a larger J3 WATER LEAK DETECTION SYSTEM . When If the J3-Point Sensor is mounted on an i surface, minimum water depths of approximately 0.5 in (12.7 mm) may be required for leak detection.

               The J3-POINT SENSOR can be interconnected with jumper cable to other J3-POINT SENSOR  or can be monitored by J3 WATER LEAK DETECTION SYSTEM or  Simple and easy to use The J3 POINT SENSOR  is compatible with all J3 WATER LEAK DETECTION PANEL system components.The Mention Price is for Bulk Qty